Grimas | Hooked nose

Roll the Derma Wax into a small string and model this as the scar is to run. Smooth the edges flat so that grease and moisture can not get underneath. Smooth the Derma Wax surface and edges off with the fingertip, using a little bit of Grimas Cleansing Cream. Dab all over with a dry, clean make-up sponge. Doing this, you remove the excess Cleansing Cream and you create a skin-texture effect.
Powder the whole with a make-up sponge with Grimas Transparent Powder to matt and fix it; then turn the sponge over and continue dabbing with the clean side until the excess powder has been removed.

DERMA WAX = Derma Wax

CLEANSING CREAM / SKINCARE CREAM = Cleansing Cream

= Transparent Powder

REMOVING THE PRODUCTS

Detach the adhesive edge with a cotton bud soaked in Grimas Mastix Remover. Scrape the Derma Wax off the skin with the spatula. Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with Grimas Cleansing Lotion.

Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover. Clean the latex prostetic afterwards using water and soap, and powder it with Grimas Transparent Powder after drying (with a dryer, if necessary). Keep in a dark place.

CLEARING UP THE MATERIALS

The sponges are disposable so you can throw them away after use. If you do want to reuse them, first rinse them under the tap with some soap or shampoo or wash them in the washing machine (in a net bag or pillow case), set to at least 60°C.

You can clean brushes with water and soap or shampoo. Put the moist hairs of the brushes back into shape by hand after washing. Dry the brushes lying flat on a towel and do not place them upright, since that causes the moisture to run down into the shaft.

> Hooked nose