Grimas | Pig

PREPARATION

Before starting, you ensure your hands and nails are well cleaned. File your nails if necessary, so that there are no snags. By doing this you prevent damages on the face and risk of infection.

Always work using clean materials (sponges, brushes, spatulas, water bowls) and change the water regularly.

Get the subject to put on any clothes beforehand that have to be put on over the head. Protect your models clothing with a hairdressing cape or a towel.

First degrease and clean the skin you are going to be working on with Grimas Cleansing Lotion. Then dry the skin with a tissue.

Place the latex application on the skin to get an impression of whether the edges are a good fit and where it is going to be glued on.

PROCEDURE

When the model keeps her mouth firmly closed, the parts should fit together well. Apply Transparent Powder to where the edge merges into the skin to mark out the exact spot. Pack some cotton wool into the nose. This absorbs the perspiration.

Pre-colour the snout with white Cake Make-up and then with pink Water Make-up (Pure).

First apply the chin and then the snout.
Apply a little Grimas Mastix Extra to the inside of the scales/adhesive edge and allow it to dry for a few seconds.
Do the following to get the correct degree of adhesion: press the latex prostetic lightly in place and then remove it again straight away. Wait a few seconds and reposition the application, pressing the edges in place with a tissue.
Protect the eyes by closing them and covering them with a tissue. Can cause serious damage to the eyes.

To get a smooth transition between the latex prostetic and the skin, even the edges off as follows: apply a thin line of eyelash adhesive to the edge of a sponge and dab this over the transition between the latex prostetic and the skin. Allow to dry with help of a hairdryer until the result is transparent. Repeat this process until a nice and even transition is obtained.

> Pig