Grimas | Quasimodo

Work from the inside outwards.
Press the obliquely cut surface onto the adhesive and work the Wool Crepe eyebrows outwards. You use scissors to create the desired model for the eyebrows. If necessary, open the structure a little and model them using the end of a pin-tail comb or the back of a brush. Repeat the process of cutting and opening if necessary until the desired result has been achieved.

WOLCRÊPE = Wool Crepe

Next, you are going to lighten/shadow with Crème Make-up, all the while emphasising the crookedness of the face (frown lines, wrinkles on the forehead, lines around the eyes).

Important areas for shading are the eye sockets, the temples, the side of the nose and below the cheekbones. You draw the lines with a flat sable-hair brush. By placing it obliquely on the skin you get a sharp edge on one side and a fading effect on the other side. To determine which side should be sharp and which side faded, you start from the centre of the face (nose). Create a fading effect towards the outside.

The parts of the face that have not been shaded now seem to have been brought forward.

If the non-shaded parts are lightened, this will enhance the effect of bringing those areas "forward". The shading and lightening must blend into the basic colour in a natural way. If necessary, blur the segments and lines that are to be faded using a dry make-up sponge. You do this with a dabbing action, without wiping.

You powder the face off with Grimas Transparent Powder, Fixing Powder or Make-up Powder. Apply the powder on top of the make-up. You can do this with a Make-up Sponge or a Velour Powder Puff. Allow to settle in and remove excess powder with a Powder-Rouge Brush.

REMOVING THE PRODUCTS

Wool Crepe that has been stuck on with Mastix Extra you remove with Mastix Remover. You can then already pull some of the hairs loose and remove them with a tissue. The remaining hairs and the adhesive you remove with a cotton wool pad and Mastix Remover. Dab it carefully onto the skin and roll the residual material off the skin.

Removing a latex application: wipe a cotton bud soaked in Grimas Mastix Remover along the adhesive edge to loosen it. Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover.

Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.

> Quasimodo