Grimas | Clown's nose square

FINISHING

To get a smooth transition between the latex prostetic and the skin, even the edges off as follows: apply a thin line of eyelash adhesive to the edge of a sponge and dab this over the transition between the latex prostetic and the skin. Allow to dry with help of a hairdryer until the result is transparent. Repeat this process until a nice and even transition is obtained.

LATEX PROSTHETICS = Latex prostetics

Apply the Crème Make-up or Camouflage Make-up with white areas around the mouth and eyes (also on top of the natural eyebrows). Take the make-up out with a clean spatula and work from the spatula, or directly from the stick. Apply it with a slightly damp latex sponge or make-up sponge onto the skin.

High eyebrows procure a surprised, naïve expression.

REMOVING THE PRODUCTS

Removing a latex application: wipe a cotton bud soaked in Grimas Mastix Remover along the adhesive edge to loosen it. Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover. Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.

CLEARING UP THE MATERIALS

Clean the latex prostetic afterwards using water and soap, and powder it with Grimas Transparent Powder after drying (with a dryer, if necessary). Keep in a dark place.

The sponges are disposable so you can throw them away after use. If you do want to reuse them, first rinse them under the tap with some soap or shampoo or wash them in the washing machine (in a net bag or pillow case), set to at least 60°C.

You can clean brushes with water and soap or shampoo. Put the moist hairs of the brushes back into shape by hand after washing. Dry the brushes lying flat on a towel and do not place them upright, since that causes the moisture to run down into the shaft.

> Clown's nose square