Grimas | Clown's nose square

STICKING ON LATEX

Attaching latex onto the skin
Apply a little Grimas Mastix Extra to the inside of the scales/adhesive edge and allow it to dry for a few seconds.
Do the following to get the correct degree of adhesion: press the latex prostetic lightly in place and then remove it again straight away. Wait a few seconds and reposition the application, pressing the edges in place with a tissue.

Protect the eyes by closing them and covering them with a tissue. Can cause serious damage to the eyes.

MASTIX EXTRA = Mastix Extra

LATEX PROSTHETICS = Latex prostetics

FINISHING

To get a smooth transition between the latex prostetic and the skin, even the edges off as follows: apply a thin line of eyelash adhesive to the edge of a sponge and dab this over the transition between the latex prostetic and the skin. Allow to dry with help of a hairdryer until the result is transparent. Repeat this process until a nice and even transition is obtained.

Apply the Crème Make-up or Camouflage Make-up with white areas around the mouth and eyes (also on top of the natural eyebrows). Take the make-up out with a clean spatula and work from the spatula, or directly from the stick. Apply it with a slightly damp latex sponge or make-up sponge onto the skin.

High eyebrows procure a surprised, naïve expression.

REMOVING THE PRODUCTS

Removing a latex application: wipe a cotton bud soaked in Grimas Mastix Remover along the adhesive edge to loosen it. Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover. Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.

> Clown's nose square